Print Page | Close Window

98 Saturn SC1, installed a AutoPage R/S

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22912
Printed Date: May 15, 2024 at 11:43 AM


Topic: 98 Saturn SC1, installed a AutoPage R/S

Posted By: gpgtp00
Subject: 98 Saturn SC1, installed a AutoPage R/S
Date Posted: December 16, 2003 at 2:56 PM

Im having a problem here. Sometimes the car will remote start and stay running and other times it will start up, run for no more than 30 seconds or so, then turn off and repeat that process 3 times til it quits trying. What gives? Thanks



Replies:

Posted By: Geeque
Date Posted: December 16, 2003 at 3:58 PM
Sounds like your having a problem with the passlock 2 bypass, check those connections, make sure you have the right resistance.

-------------
Gary Kline
MECP Master Technician




Posted By: gpgtp00
Date Posted: December 16, 2003 at 4:03 PM
theres no passlock on this car.




Posted By: Geeque
Date Posted: December 16, 2003 at 4:06 PM

Where are you getting the main power for the r/s at?



-------------
Gary Kline
MECP Master Technician




Posted By: gpgtp00
Date Posted: December 16, 2003 at 4:12 PM
the ignition switch harness. i think i already know what your gonna say.




Posted By: JWorm
Date Posted: December 16, 2003 at 10:04 PM
What wire are you using for tach? Does the problem happen when the car is only hot, cold, or both? I recommend using one of the injector wires on that car for tach.




Posted By: Geeque
Date Posted: December 17, 2003 at 10:22 AM
Also run the main power wire to the battery. Also I think i remeber some sort of problem i had with a factory alarm module behind rear passenger B pillar i had to interupt a circuit there for some reason. Not sure if the vehicle has a security system or not , but you might want to post a forum to see if this is an issue or not.

-------------
Gary Kline
MECP Master Technician





Print Page | Close Window