98 lumina, bulldog remote starter
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=23380
Printed Date: May 14, 2024 at 1:07 PM
Topic: 98 lumina, bulldog remote starter
Posted By: mikejr0046
Subject: 98 lumina, bulldog remote starter
Date Posted: December 26, 2003 at 6:20 PM
Trying to hook up bulldog remote starter,lookin for the ignition wires one and two.Bulldog says pink and violet.I found two pinks and one violet that are hot when in the run position.How do i know which one to use?The other thing is these are both light gauge wires 16 or 18, the wires from bulldog are alot heavier.
-------------
mikejr0046
Replies:
Posted By: Teken
Date Posted: December 26, 2003 at 8:19 PM
The wire you require will show +12 volts in the *ON* and *CRANK* position.
Or as it is stated in other manuals it is the wire that shows 0 volts in the *OFF* & *ACCESSORY* position. And 12 volts in the ignition while in the *START* and *RUN* position.
I hope that helps.
Regards
EVIL Teken . . .
Posted By: muaiad97
Date Posted: December 27, 2003 at 10:42 PM
This is wiring daiagram lumina 1998 +12 v red starter yelow ign#1 pink ign#2 brown acc orenge
Posted By: JWorm
Date Posted: December 28, 2003 at 10:11 AM
The pink wire will be about 12 gauge. You have the wrong wires. Some GM's have a 16 gauge second ignition or starter wire, but not this vehicle if I remember correctly.
|