DEI 555L pink and blue/black wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=25995
Printed Date: June 08, 2024 at 5:49 PM

Topic: DEI 555L pink and blue/black wire

Posted By: aleefers
Subject: DEI 555L pink and blue/black wire
Date Posted: February 07, 2004 at 9:40 AM

I am using a Dei 555L module to bypass the passlock 2 on a cavalier with a bulldog 1200e remote starter. Well it says that the blue/black wire is status input (-) so what wire should I connect it to on the remote starter? It says the pink wire is ignition input (+) and should be connected to the wire on the starter that connects to the main ignition, which wire is this?

Replies:

Posted By: NowYaKnow
Date Posted: February 07, 2004 at 12:39 PM

The pink wire will go to the pink (+) ignition 1 wire in your car. Or tap it in to the ignition 1 (+) output on your remote start unit (white wire?) which will go to the pink (+) ignition 1 wire in your car.

The blue/black (-) status wire is going to connect to the ignition NEGATIVE output. Which on your unit I believe is also white.

If your ignition 1 (+) and ignition (-) are both white wires on your module like it seems, make sure you connect to the right ones!

Good luck,

Mike

Posted By: aleefers
Date Posted: February 07, 2004 at 3:59 PM

I found out that a status wire is the same as an activation wire and on my remote starter its called an activation wire. Then I found the ignition positive wire on the starter so now it works great. Just wish I had my 30 bucks back from buying the piece of sh*t bulldogg 791

Print Page | Close Window