Start: | | YELLOW | IGNITION SWITCH HARNESS * |
Ignition #1: | | PINK | IGNITION SWITCH HARNESS |
Ignition #2: | | WHITE | IGNITION SWITCH HARNESS |
Ignition #3: | | N/A | **** |
Accessory: | | ORANGE | IGNITION SWITCH HARNESS |
Brake Light: | | WHITE | AT SWITCH ABOVE BRAKE PEDAL |
Tach Signal: | | WHITE | IN BLUE PLUG AT THE ECM ON DRIVER'S SIDE OF MOTOR |
Parking Lights: | | BROWN (+) | DRIVER'S KICK PANEL |
Headlights: | | | |
OEM Alarm Disarm: | | LT. GREEN (-) | INSIDE OF DRIVER'S DOOR AT MODULE |
OEM Alarm Arm: | | | |
Diesel Glow Plug: | | N/A | |
Clutch Bypass Wire: | | N/A | |
Notes: | | * This Vehicle Is Equipped With GM's PASSLOCK II Anti-Theft System; Use Universal Alarm Bypass Module or Vehicle Specific Bypass DTI #23545 ****All DesignTech remote starters except the 2xx22 have an ignition 3 output - it is the WHITE/ black in the 'control harness.' This wire will be used to control the bypass module, if needed. |
Constant +12 Volts: | | RED | IGNITION SWITCH HARNESS |
Starter Kill: | | YELLOW | IGNITION SWITCH HARNESS * |
Ignition +12 Volts: | | PINK | IGNITION SWITCH HARNESS |
Dome Lights/Superv: | | GRAY/BLACK (+) | UNDERNEATH DASH AT COURTESY LAMP |
OEM Horn: | | BLACK / YELLOW (-) | STEERING COLUMN HARNESS |
Power Lock: | | SEE NOTE BELOW *** | CAUTION - DATABUS SYSTEM |
Power Unlock: | | SEE NOTE BELOW *** | INTERFACE MODULE RECOMMENDED! |
Trunk Release: | | N/A | |
Alarm Input Wire: | | GRAY/BLACK (+) | UNDERNEATH DASH AT COURTESY LAMP |
Notes: | | *This vehicle uses an extremely complex lock/unlock circuit. To Lock/Unlock, we recommend use of the 23561 Door Lock Interface module, available through DesignTechs sales department at 800-337-4468 . Alternatively, you can wire inside each door for reverse polarity door locks. The 23561 module is easier to install, less expensive, and requires less wiring than the reverse polarity/relay method. Motor Wires, should you choose the reverse polarity method, are Gray for Lock and Tan for unlock. SOME of these vehicles have a switch on the right rear panel which can lock/unlock all doors as a positive trigger system. If so equipped, the wires are Lt Blue for lock and White for Unlock. Connection of the locks without the module is not supported. |
-------------
"Big" Mike
Double Take
Fremont, Ne
remember to check all your wires with a dmm not a test light!!
i take no responsibilty whatsoever for the vailidty of the info nor consequences thereof
have fun with that one! if you havent done one its sorta a pain.
-------------
Hey to install a slave RS on this truck I want to use the unlock motor on the drivers or pasanger door, the rsd need to receive a neg pulse ( 1 or 2) to intiate the starter sequence. Where and what color is this wire
thanx
-------------
irnotslow