Clutch Bypass for Remote Start 02 Blazer

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=28915
Printed Date: June 15, 2024 at 5:12 PM

Topic: Clutch Bypass for Remote Start 02 Blazer

Posted By: stevent
Subject: Clutch Bypass for Remote Start 02 Blazer
Date Posted: March 23, 2004 at 1:32 PM

I am installing a Valet 554r into a 2002 Chevrolet Blazer Extreme 2WD Manual transmission. I am also installing a Peripheral NSS (Neutral Saftey Switch) so it wont get started in gear. I can't figure out how to bypass the clutch during remote start? Has anyone had experience with an S-10 or Blazer with a manual transmission? There are 5 or 6 wires coming off the clutch. Help!

Replies:

Posted By: kgerry
Date Posted: March 23, 2004 at 3:28 PM

the Valet 554 is NOT to be installed in anything but an automatic transmission vehicle....... buy a dedicated manual transmission combo unit, like the Autostart AS-6070TW or equivalent......

-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979

Posted By: its_radio_shop
Date Posted: March 23, 2004 at 10:54 PM

I agree with kgerry, I would only use a dedicated manual transmission RS unit with your vehicle. The NSS unit says it will allow you to safely add a RS unit to a standard transmission...thats up to you. I normally dont comment on on automatic RS units on a manual transmission but this NSS unit looks like if properly installed should keep it safe.

Use your DMM and look for 2 wires that show continuity between each other when the clutch is depressed. Short those same two wires together with the clutch out and try to start. There may be 2 pairs of wires you need to do this with. Give it a try.

Posted By: Steve #1
Date Posted: March 24, 2004 at 2:09 AM

On most clutch switches you have wiring for the cruise control and the starter safety switch. Make sure you test for the safety switch by fully depressing the clutch. From looking at the install guide,you want to use the light GREEN/ black from the RS to close the bypass relay.

Posted By: stevent
Date Posted: May 06, 2004 at 12:18 PM

Is there anyone who has actually done a remote start on a manual extreme? Also, does anyone know of a place to get the peripheral NSS cheaper than $50?

Posted By: kgerry
Date Posted: May 06, 2004 at 5:16 PM

LOL nice to see you put such a high price value on safety........

-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979