Print Page | Close Window

1999 Ford fiesta (EU) Wiring Diagram

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=34282
Printed Date: June 11, 2024 at 12:40 PM


Topic: 1999 Ford fiesta (EU) Wiring Diagram

Posted By: ez_thefix
Subject: 1999 Ford fiesta (EU) Wiring Diagram
Date Posted: June 21, 2004 at 5:00 AM

I need a wiring diagram for a 1999 ford fiesta studio (european).

I am planing to install a compact alarm. I am thinking that if I don't install any remote entry, the instalation should be pretty simple; the car already has a factory starter kill, which I would leave intact. All I need is for the siren to go off if someone tried to break in to steal anything inside. I am looking at this micro scan model: AN313 - 116.99 (RRP £137.99) https://www.microscanalarms.co.uk/system/index.htm

Thanks!

 




Replies:

Posted By: jfk51502003
Date Posted: June 22, 2004 at 10:58 AM
DIRECTWIRE™ WIRING INFORMATION - FORD / FIESTA (UK) / 1999 / Security

[PRINT THIS PAGE]

12volts
Starterblk/blu or grey ignition harness
Ignitionblack or green ignition harness
Power Lockyel/blk or yel/blu + either kickwell
Power Unlockwht/vio or wht/grn + either kickwell
Lock Motor
Unlock Motor
Disarm Defeat
Parking Lights+blue & blu/red at the steering column
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Door TriggerBLACK/ red - n/s kick panel
Dome Supervision
Trunk/Hatch PinORANGE / black at the bootlight
Hood Pin
Trunk/Hatch ReleaseORANGE / black at the release switch
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
TachometerWHITE/ blue alternator
Horn Trigger
Memory Seat 1
Memory Seat 2
Memory Seat 3
posted_image
Immobilizer Bypass Module: Not Available


This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.





Print Page | Close Window