Dodge RAM Pick-Up Factory Alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=382
Printed Date: June 03, 2024 at 10:03 PM

Topic: Dodge RAM Pick-Up Factory Alarm

Posted By: sabioundus
Subject: Dodge RAM Pick-Up Factory Alarm
Date Posted: April 18, 2002 at 11:17 PM

Hi, Everyone. About three months ago I installed a Vampire Remote Starter on a 97' DODGE RAM Pick-Up full size. I has factory security (FS) system. I was not able to disarm the FS with the Vampire, so what I did was to ground the inputs of the FS (the dome light) which was the signal that armed the FS after the last door was closed. It was working fine but now the FS is comming out and it turns off the engine because it can control the fuel system. So some times it turns off the truck on the road.

Any ideas on this issue?

How can I do the Disarm of the FS with the Vampire?

Regards,

Replies:

Posted By: Velocity Motors
Date Posted: April 19, 2002 at 5:25 AM

FACTORY DISARM

L GRN/ORG

24 PIN CONN BEHIND DRV DASH

There is a DISARM wire coming from the Vampire alarm that you need to connect to the above wire. This should do the trick. If not you can disconnect the factory alarm system completely from it's harness.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: sabioundus
Date Posted: April 19, 2002 at 6:54 PM

Thanks Jeff, but this is the up-date.

I had this information and I did not find the mentioned wire. That is why I have done what I mentined before (ground the input signals to the FS). I found the factory alarm, but if I disconnet it the truck will not start, even whit the key. I need to disarm the FS with its original transmiter in order to run the truck.

Any suggestions?

Regards,