compustar CN1

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=41382
Printed Date: May 02, 2024 at 6:58 AM

Topic: compustar CN1

Posted By: radeon200
Subject: compustar CN1
Date Posted: October 21, 2004 at 9:00 PM

wow, compustar installation guide is a very poor written manual. i hope you compustar expert folks can help. i would like to map out all the wires before i start the installation. On CN1, there are 2 constant power with 30amps that i will cut and attach them near to the battery. if that is good i would like to move on to the relays. the list below is questions on CN1. i have a Dodge Grand Caravan 2005. thanks i appreciate the effort.

CN1

1) red - 12v
2) gr/wh - pking light

3) RED / wh - 12v
relay - blue - 2nd ignition ???
- violet - starter ?????

4) white - accessory

5) violet - relay ???
6) Yellow - relay ??? -
7) red - relay ???
green - ignition -?????

8) black - ground

----------------------------------

3) this wire has a relay out with 2 wires. one of the 2nd ingnition and the other may be for the starter? what about the 3rd ignition that nissan maximas have? i guess i do not need to deal with the 3rd ignition.

5)6)7) are connected to one relay and out from the relay with 2 wires. yellow is for the starter? yellow/blk is for _____?

7) green is for the ignition

Replies:

Posted By: darkowy
Date Posted: October 23, 2004 at 5:56 AM

Check this link

https://www.compustar.org/support/manuals/wiring_manuals/CM3000_wiring_manual.pdf

Posted By: ThurzNite
Date Posted: December 15, 2004 at 1:45 AM

dood, i jsut spent freakin 2hr trying to figure the wiring diagram out using the basic install manual. Darkowy, if I saw your post earlier, I woulda cut my time down to 0. Well, at least a lot shorter than 2hr. thanx for the link!
Jae

Posted By: ThurzNite
Date Posted: December 15, 2004 at 2:00 AM

Another question. for CN5, wires 1 and 2. They are for Rearm and Arm. I read what they do. Functionally, what could they operate? I'm looking for ideas.
Tbanks.
Jae

Posted By: darkowy
Date Posted: December 15, 2004 at 9:49 AM

You should use those wires to disarm (CN5 Pin 2) and arm (CN5 Pin 1) your factory alarm if your car is equipped with one.

Posted By: ThurzNite
Date Posted: December 18, 2004 at 1:52 PM

I'm just full of questions.
CN1 Pin 3. I understand that the fused wire connects to constant 12v. What about the blue and purple wires coming off the relay? My car (97 nissan maxima) has a 2nd accessory and 2nd starter.

Thanx!

Jae