Print Page | Close Window

2005 Dodge Grand Caravan Remote Start/Alarm Wiring

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=41383
Printed Date: March 28, 2024 at 5:39 PM


Topic: 2005 Dodge Grand Caravan Remote Start/Alarm Wiring

Posted By: radeon200
Subject: 2005 Dodge Grand Caravan Remote Start/Alarm Wiring
Date Posted: October 21, 2004 at 9:20 PM

Iam trying to install a remote start/alarm on a 2005 Dodge Grand Caravan. I need to get the wiring diagram. Could somebody provide some help locating the diagram as well as providing any tips or information.  Thank you.



Replies:

Posted By: JWorm
Date Posted: October 21, 2004 at 9:51 PM
Same car

https://www.the12volt.com/installbay/forum_posts.asp?tid=41335&PN=1




Posted By: eurotek
Date Posted: December 21, 2004 at 10:59 PM

JWORM, you are wrong, this vehicle is different

for one, the starter is a negative





Posted By: KarTuneMan
Date Posted: December 21, 2004 at 11:07 PM

DIRECTWIRE™ WIRING INFORMATION - DODGE / CARAVAN / 2005 / Remote Start

[PRINT THIS PAGE]

12voltslt. blue/red (10A) + ignition harness
Starteryellow + ignition harness
Second StarterPURPLE / brown - ignition harness
Notes: The second starter wire is negative trigger thru a 180 ohm resistor. MUST use a relay. Refer to DirectFax document 1083 for wiring information.
Ignitionpink/white + ignition harness
Second IgnitionN/A
Third IgnitionN/A
Accessorynot required for remote start
Second AccessoryN/A
KeysenseN/A
Power LockPURPLE / dk. green - BCM, white plug, pin 21
Notes: Lock is negative trigger thru a 5.3K ohm resistor. Unlock is negative trigger thru a 2.0K ohm resistor. MUST use relays.

The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Power Unlocksame as power lock wire
Lock Motortan/white 5wiBCM, green plug, pin 10
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Unlock Motortan/lt. green 5wiBCM, green plug, pin 28
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Parking Lights+WHITE/ brn (L), WHITE/ org (R) + driver kick, harness to rear
Parking Lights-WHITE/ brown - switch or BCM, gray plug, pin 21
Notes: The parking lights are negative trigger thru a 2.1K ohm resistor. There is a rest resistance on the wire, so MUST use a relay to isolate away from the switch. See DirectFax document 1082 for wiring information.

The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
HazardsWHITE/ dk. blue - switch or BCM, gray plug, pin 31
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Turn Signal(L)wht/lt blu (F), wht/dk grn (R) + BCM, green plug, pins 1, 2
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Turn Signal(R)WHITE/ tan (F), WHITE/ brown (R) + BCM, green plug, pins 3, 4
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Reverse LightWHITE/ lt. green + BCM, green plug, pin 9
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Door Triggersee notes - BCM, white plug
Notes: The driver door trigger is purple in pin 6, the passenger door is PURPLE / white in pin 7, the left sliding door is PURPLE / gray in pin 8, and the right sliding door is purple / YELLOW in pin 5. Use all four wires and diode isolate each. Also have to diode isolate from the BCM. Refer to DirectFax document 1076 for wiring information.

The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Dome Supervisionyellow/brown or yellow/white + BCM, white plug, pin 33
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Trunk/Hatch PinPURPLE / orange - BCM, white plug, pin 29
Notes: A diode must be placed inline on this wire to avoid problems with the dome lights and parking lights.

The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Hood PinPURPLE / lt. blue (export model) - BCM, white plug, pin 30
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Trunk/Hatch ReleasePURPLE / tan - BCM, green plug, pin 6
Notes: Hatch release is negative trigger thru a 1.69K ohm resistor. MUST use a relay.

The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Power Sliding DoorPURPLE / dk. blue - BCM, white plug, pin 1
Notes: Left power sliding door is negative trigger thru a 1.5K ohm resistor. Right power sliding door is negative trigger thru a 2.7K ohm resistor. MUST use relays.

The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Factory Alarm Armarms on lock with door open
Factory Alarm Disarmfactory remote only
Disarm No Unlockwith ignition and Sentry Key
TachometerNOT BROWN / white ac ign coil pack or any fuel injector
Wait to startN/A
Brake WireWHITE/ tan + brake pedal switch
Parking Brakedk. GREEN / WHITE - parking brake switch
Horn Triggerdk. GREEN/ purple - steering column
Memory Seat 1PURPLE / brown - BCM, green plug, pin 24
Notes: Memory seat 1 is negative trigger thru a 6.8K ohm resistor. Memory seat 2 is negative trigger thru a 2.1K ohm resistor. MUST use relays.

The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
Memory Seat 2same as memory seat 1 wire -
Memory Seat 3N/A -
posted_image
Immobilizer Bypass Module:Required: YesType: Sentry KeyPart #: 556U or 555U
Notes: Standard on SXT models. Optional on SE models.


posted_image
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.

posted_image


-------------




Posted By: KarTuneMan
Date Posted: December 21, 2004 at 11:10 PM
12volts
 lt. blue/red (10A)
 +
 ignition harness
  
Starter yellow  +  ignition harness   
Second Starter PURPLE / brown  -  ignition harness  
Ignition pink/white  +  ignition harness   
Second Ignition N/A       
Third Ignition N/A       
Accessory not required for remote start       
Second Accessory N/A       
Keysense N/A       
Power Lock PURPLE / dk. green  -  BCM, white plug, pin 21  
Power Unlock same as power lock wire       
Lock Motor tan/white  5wi BCM, green plug, pin 10  
Unlock Motor tan/lt. green  5wi BCM, green plug, pin 28  
Parking Lights+ WHITE/ brn (L), WHITE/ org (R)  +  driver kick, harness to rear   
Parking Lights- WHITE/ brown  -  switch or BCM, gray plug, pin 21  


-------------




Posted By: eurotek
Date Posted: December 21, 2004 at 11:18 PM
what is the disarm defeat? 





Print Page | Close Window