2002 Mits Galant keysense wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=43883
Printed Date: June 01, 2024 at 1:17 PM

Topic: 2002 Mits Galant keysense wire

Posted By: srusin1
Subject: 2002 Mits Galant keysense wire
Date Posted: November 27, 2004 at 10:38 AM

How would i interupt the keysense wire on this car. WHen i meter it, it reads ground without the key and .8 volts with the key inserted.

Replies:

Posted By: draasch
Date Posted: November 27, 2004 at 11:21 AM

what are you looking to do????

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: srusin1
Date Posted: November 27, 2004 at 11:48 AM

im trying to install a remote start, i have the mit-pku bypass. It does not want to work, i am not sure if the bypass isnt programmed right or i need to inteeruppt the keysense wire to disable the factory starter disable.

Posted By: snguyen
Date Posted: November 27, 2004 at 2:35 PM

If I remember right, the pku-mit is a simple connection to a 12 volt source and a groundout from the remote starter. Need to make atleast 3 loop around the ignition cylinder. Once you have this connected, then you need to program using 2 valid keys.

Print Page | Close Window