03 Olds Alero aftermarket keyless entry
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=44055
Printed Date: April 28, 2024 at 8:42 PM
Topic: 03 Olds Alero aftermarket keyless entry
Posted By: brsexton
Subject: 03 Olds Alero aftermarket keyless entry
Date Posted: November 29, 2004 at 1:57 PM
Hello all,
I have a 2003 Alero GX. When the car was new it did not come with keyless entry, so i had it installed by an audio shop in my old town. The system they put in was a DEI/ACDelco keyless entry kit. I have no idea what the numbers on the unit are. The numbers on the remote are EZSDEI476 if that helps. Anyway, I lost my book during my move and I was wondering how I can disable the horn honk feature when I lock/unlock my doors. I now live in a quite area with lots of duplex units and I would like to turn this feature off but I have no idea how.
Thanks for your help...
Replies:
Posted By: kgerry
Date Posted: November 29, 2004 at 2:05 PM
you'll have to ascertain what model you have... it's the # on the module under the dash, not the remote part # on the transmitter....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: brsexton
Date Posted: November 29, 2004 at 3:32 PM
Ok, I think I have what you need. The system is GM's VKE1000 Keyless entry made by DEI. P/N 12463355. Hope this helps.
Posted By: sparkie
Date Posted: November 29, 2004 at 5:58 PM
On the module inside the dash you will find four screws. Take out the 4 screws and cut the RED wire loop on the circuit board. This will eliminate the lock/unlock chirps, but retain the horn operation for panic.
-------------
sparky
Posted By: brsexton
Date Posted: November 29, 2004 at 7:28 PM
sparkie wrote:
On the module inside the dash you will find four screws. Take out the 4 screws and cut the RED wire loop on the circuit board. This will eliminate the lock/unlock chirps, but retain the horn operation for panic.
Thanks so much for the quick reply. I will try to get to that tomorrow. Thanks again for your help
|