2005 yukon R/S

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=44770
Printed Date: June 06, 2024 at 2:54 AM

Topic: 2005 yukon R/S

Posted By: splicerman
Subject: 2005 yukon R/S
Date Posted: December 09, 2004 at 12:29 AM

I have a clifford solaris 5 installed in my 05 Yukon. When I R/S it (with system armed) the driver info says "service stability control", the abs light goes on, and the traction control light stays on. Then the engine shuts down after a few seconds and starts up again automatically with no problem. Any thoughts or concerns? Thanx.

Replies:

Posted By: hagmanti
Date Posted: December 09, 2004 at 9:50 AM

You are most probably not powering an ignition wire that should be powered.

My $.02,

Me

Posted By: gfella2000
Date Posted: December 09, 2004 at 2:10 PM

Make sure you have ignition #1 (Pink) and ignition #2 (thin White) connected correctly.

-------------
GFELLA 20000000000

Posted By: splicerman
Date Posted: December 09, 2004 at 9:04 PM

Fixed it. It turned out I needed it to learn the RPM for it to remote start without it shutting down and restarting.......................Go figure..................

Print Page | Close Window