Print Page | Close Window

2000 tundra remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=45397
Printed Date: May 29, 2024 at 6:09 AM


Topic: 2000 tundra remote start

Posted By: cuttdawg85
Subject: 2000 tundra remote start
Date Posted: December 17, 2004 at 1:11 AM

gonna install a dei remote start....any pointers on how to diarm the factory alarm? what do i need to do to accomplish this? Also any tips about wiring the door locks? says u have to diode isolate which ive never done.

Thanks




Replies:

Posted By: draasch
Date Posted: December 17, 2004 at 9:20 AM
Make:   Toyota
Model: Tundra
Year:    2000-01
This Database Was Last Updated On:    9/16/2004
Index #: 1604


Alarm
Constant 12 volts WHITE/ RED & WHITE IGNITION SWITCH HARNESS
Ignition 12 volts BLACK/ RED IGNITION SWITCH HARNESS
Starter GREEN/ BLACK IGNITION SWITCH HARNESS
Dome Light BLACK/ WHITE (-) 9 PIN CONN DRIVER SIDE JUNCTION BLOCK
Trunk Pin Switch N/A
Parking Lamp GREEN (+) 12 PIN CONN DRIVER JUNCTION BLOCK
Power Lock WHITE/ GREEN 12 PIN CONNECTOR IN
Power Unlock RED / YELLOW DRIVER KICK PANEL * #209

* Child Safety Lock - RED / BLUE (-) In Same Connector As Door Locks. #209- See Child Safety lock diagram.


View Diagrams




Accessories
Window Up D\ LIGHT GREEN P\ RED / BLACK @ MAIN #211
Window Down R/ BLUE / YELLOW S/ RED / GREEN SWITCH
Ign Key Warn PINK/BLACK (-) STEERING COLUMN HARNESS
Trunk Release N/A
OEM Horn GREEN/ RED (-) STEERING COLUMN HARNESS *
Headlights GREEN/ YELLOW (-) AT HEADLIGHT SWITCH *
OEM Alarm Arm N/A NO OEM ALARM PRESENT
OEM Alarm Disarm N/A IN SCHEMATICS


* Located In 4 Pin Square Connector On Rear Of Junction Block In Behind Driver Lower Dash. #211 See Reversal Rest At Ground Power Window Circuit Diagram.


View Diagrams




Remote Start
Tach Signal BLUE/WHITE TOP REAR OF ENGINE (8 CYL) *
Ignition #2 BLACK / YELLOW IGNITION SWITCH HARNESS
Ignition #3 N/A
Accessory BLUE/RED IGNITION SWITCH HARNESS
Neutral Safety NOT GROUNDING TYPE - OEM SWITCH OPENS STARTER CIRCUIT
Brake Light GREEN / WHITE (+) AT SWITCH ABOVE BRAKE PEDAL **
Reverse Light RED / BLACK (+) BACK-UP RELAY BOTTOM LEFT OF J/B
Rear Window Defrost N/A


* 6 Cylinder - BLUE At ECM Behind Passenger Dash. ** Also Located in 13 Pin Connector Left Side Of Driver Junction Block.
https://wiringinstructions.com/209.htm

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt




Posted By: cuttdawg85
Date Posted: December 17, 2004 at 10:39 AM
any idea why it dosent show the factory alarm? The truck i have has keyless and beeps when locking and unlocking...so just assumed it was factory alarm!!



Posted By: profuse007
Date Posted: December 17, 2004 at 10:45 AM
theres alarm but i didnt remember disarming it as i did it on my buddy's 01 tundra...i think.

|FCTRY ALRM DISARM|blue/black          |- |drivers door harness       

thats the wire for disarm.

the only thing you need to worry about is that; does it passively (auto) arm itself? if not, i dont see a reason to mess w/ the factory alarm.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).


Print Page | Close Window