Installed Alarm - No Turn Signals
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=48573
Printed Date: May 01, 2024 at 3:58 AM
Topic: Installed Alarm - No Turn Signals
Posted By: 65Mustangs
Subject: Installed Alarm - No Turn Signals
Date Posted: January 25, 2005 at 3:21 PM
Installed an alarm and keyless into a '89 Jeep Cherokee, when completed turn signals no longer worked. There are two blue wires going into the headlamp switch, used one for running lights flash, when alarm armed. Any ideas how to troubleshoot turn signals? Need info on wiring to troubleshoot. I think either a relay got shorted out, or something was left disconnected, but am unfamilier with turn signal wiring. Please Help!
Replies:
Posted By: TJ92Civic
Date Posted: January 25, 2005 at 3:39 PM
| PARKING LIGHTS + | blue/red | | dr. kick panel |
Thats what I found for parking lights. Check the fuses to make sure they are not blown. tim
Posted By: kgerry
Date Posted: January 25, 2005 at 3:43 PM
also check to make sure the hazard switch isnt halfway between on and off.....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: kidtransam
Date Posted: January 25, 2005 at 6:51 PM
a quick test would be to unplug the alarm brain and see if the turn signals work. if they do, its in the wiring of your alarm..if not..you have blown a fuse or disconnected something.
-------------
With a torch and a big enough hammer...it WILL friggin fit!!
Posted By: Javelin3o4
Date Posted: January 28, 2005 at 1:07 AM
i was gonna also suggest checking the hazard switch cause on most cars the turn signals are wired through the hazard switch and if its unplugged the signals dont work, so try hitting the hazard button and see if the work.
|