Horn Honking with remote start, 99 Jeep
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=48716
Printed Date: June 10, 2024 at 4:13 PM
Topic: Horn Honking with remote start, 99 Jeep
Posted By: abad355ta
Subject: Horn Honking with remote start, 99 Jeep
Date Posted: January 27, 2005 at 10:24 AM
I installed a DEI Valet alarm on my wifes 99 Jeep GC with both interfaces, door lock and VATS system. Now the horn honks when I remote start it. It is really aggravating. Also I cannot figure out how to get the parking lights to stay on when remote started. The way I had it, they just flashed.
any help
ToDD
Replies:
Posted By: metaverse
Date Posted: January 27, 2005 at 11:15 AM
what is the model of the alarm ? The horn honk and parking lights are programmable options on certain alarms. Did you look through the install manual to see if they can be changed ?
Posted By: gus1
Date Posted: January 27, 2005 at 11:31 AM
You can change the parking lights to constant in the install programming. As far as the honk goes.... is it one honk, then start? Does it do it only when armed by the factory remote, or locked by the starter?
Gus
-------------
Wherever I go, that is where I end up......
Posted By: Velocity Motors
Date Posted: January 27, 2005 at 11:41 AM
Depending on the bypass module used, the horn honk is connected to the programmable options on the modules ( if connected ). Did yo8u connect the horn wire to anywhere on the DEI unit or the modules ?
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: Montrealler
Date Posted: January 27, 2005 at 12:27 PM
If the installer did not hook up the door lock he also probably didn't disarm the factory alarm of the vehicule. Ther is how to check lock the vehicule using the Jeep factory remote. Wait a full minute. Then , remote start . Does the horn honk ?.. Test 2.....
Unlock the door and do not arm the factory alarm of the vehicule. Wait a Full minute. Remote start ......
If in the first test the horn honk and in the second the horn remain silent that mean that the installer is disarming the alarm with the transponder and the ignition wich is causing a timing problem sometimes ..
Must disarm before remote start.
Posted By: jmr964
Date Posted: January 27, 2005 at 12:29 PM
If the horn honks when you lock it with the factory remote it will honk when its remote started because the remote starter locks the doors when u start it with the remote. Go to the overhead console and turn off the horn honk when locking the doors. Jason
Posted By: abad355ta
Date Posted: January 27, 2005 at 12:31 PM
jmr964 wrote:
If the horn honks when you lock it with the factory remote it will honk when its remote started because the remote starter locks the doors when u start it with the remote. Go to the overhead console and turn off the horn honk when locking the doors.
Jason
did that, its off
thx
Posted By: abad355ta
Date Posted: January 27, 2005 at 12:34 PM
metaverse wrote:
what is the model of the alarm ? The horn honk and parking lights are programmable options on certain alarms. Did you look through the install manual to see if they can be changed ?
DEI 554R. the options are off, and it just started honking.
thx
Posted By: abad355ta
Date Posted: January 27, 2005 at 12:36 PM
gus1] wrote:
You can change the parking lights to constant in the install programming. As far as the honk goes.... is it one honk, then start? Does it do it only when armed by the factory remote, or locked by the starter?
Gus
I will see if it does it factory disarmed. The horn only honks when rtemote started
Posted By: abad355ta
Date Posted: January 27, 2005 at 12:38 PM
Velocity Motors wrote:
Depending on the bypass module used, the horn honk is connected to the programmable options on the modules ( if connected ). Did yo8u connect the horn wire to anywhere on the DEI unit or the modules ?
did not connect horn anywhere. I m thinking the serial bus wire is doing it
T
Posted By: abad355ta
Date Posted: January 27, 2005 at 12:41 PM
Montrealler wrote:
If the installer did not hook up the door lock he also probably didn't disarm the factory alarm of the vehicule. Ther is how to check lock the vehicule using the Jeep factory remote. Wait a full minute. Then , remote start . Does the horn honk ?.. Test 2.....
Unlock the door and do not arm the factory alarm of the vehicule. Wait a Full minute. Remote start ......
If in the first test the horn honk and in the second the horn remain silent that mean that the installer is disarming the alarm with the transponder and the ignition wich is causing a timing problem sometimes ..
Must disarm before remote start.
Will try ASAP. wifes at work. thanks for tshooting
T
Posted By: abad355ta
Date Posted: January 27, 2005 at 12:45 PM
Montrealler wrote:
If the installer did not hook up the door lock he also probably didn't disarm the factory alarm of the vehicule. Ther is how to check lock the vehicule using the Jeep factory remote. Wait a full minute. Then , remote start . Does the horn honk ?.. Test 2.....
Unlock the door and do not arm the factory alarm of the vehicule. Wait a Full minute. Remote start ......
If in the first test the horn honk and in the second the horn remain silent that mean that the installer is disarming the alarm with the transponder and the ignition wich is causing a timing problem sometimes ..
Must disarm before remote start.
OK, will try tonite. I installed the alarm. will try to disarm before rstarting. It just started honking all of the sudden
thx for tshooting
T
|