hey whats up guys i tried hooking up the domelight supervision in that car and i cant seem to get it to work i was using the installation guide and schematic to do that feature for that car
now this is what i usually do I would tie the doortrigger wire (-) which is green into the domelight supervision wire which is (-) black and when i follow the schematic from the book i cant get it to work
now is there anyone out there who can please send me some info on this feature
i got this schematic off the 12volt site
87 ground
86 to alarm (-) illuminated output
30 negative door trigger
85 to fused 12v
this is what i am a little confused with the (-) alarm illuminated output what is that about is that the domelight wire BLACK/ white
now should i just leave the BLACK/ white wire along with the door trigger green connected together and run that to 86
then all i have to do is just connect a wire from the door trigger in my case i am using the domelight wire for the door trigger from the car side , just connect a wire from the car side to the relay pin 30
i am probably confusing my self but anyways can some one please help me out thanks i really appreciate it
-------------
Kenny
check it out man. just tie the door trigger input and the BLACK/ white domelight supervision output together and tap them into the same wire. theres another BLACK/ white wire on that alarm that is the polarity input for domelight supervision. its on the 6pin lock and unlock harness. ground that wire.
-------------