tach to voltage sensing

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=49690
Printed Date: June 01, 2024 at 5:29 PM

Topic: tach to voltage sensing

Posted By: gcorrea
Subject: tach to voltage sensing
Date Posted: February 09, 2005 at 12:37 AM

should a rs have both types of inputs in order to use either one, or can the same tach input be hooked up to voltage sensing. if so where would it be hooked up to. my la-z-start rs only runs for about 5 minutes then shuts down, but only when the engine is cold. when the engine is up to "normal" temperature ill remote started and it will last the full 15 minuets i have it programed to. any ideas to why it wont last the full cycle with a cold engine.

-------------
gcorrea

Replies:

Posted By: thepencil
Date Posted: February 09, 2005 at 9:44 AM

You have to choose either one, but not both. I used tach on all my install. One thing you can do is try resetting the remote starter unit and unplug the unit. Relearn the tach and set the running cycle to run longer than you normally would and see if that helps.

-------------
Be careful whose advice you buy, but be patient with those who supply it. posted_image

Print Page | Close Window