Print Page | Close Window

tachless viper 791xv

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=49974
Printed Date: May 17, 2024 at 9:28 PM


Topic: tachless viper 791xv

Posted By: srusin1
Subject: tachless viper 791xv
Date Posted: February 12, 2005 at 6:55 PM

Im not sure wether I should connect the tach wire. I want to connect it to the crankshaft sensor at the ecm or not at all. What are peoples experiences with the tachless operation of the viper?



Replies:

Posted By: slammedb5
Date Posted: February 13, 2005 at 3:06 AM
Try finding tach at the fuel injectors, or at the coil. Worst case, use voltage sense, works just fine.

-------------
EK Civic
security
no audio






Posted By: auex
Date Posted: February 13, 2005 at 11:43 AM
This is getting annoying. If you are still going with the G35 coupe then either use the wire listed below or put the alarm into voltage sensing. But just make a decision!

DEI] G wrote:

5 Tachometer NOT black or WHITE/ blue   ac   any ignition coil


And incase it is the maxima


DEI] wrote:

NOT red or black   ac   any ignition coil or fuel injector




-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.





Print Page | Close Window