2000 Camry Tach Wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=50442
Printed Date: May 20, 2024 at 4:25 AM

Topic: 2000 Camry Tach Wire

Posted By: illmattix
Subject: 2000 Camry Tach Wire
Date Posted: February 19, 2005 at 11:38 AM

Just wondering if anyone knows exactly where the tach wire is on a 2000 Camry. The sheet says Black(AC) or Yellow/Red Ignition Driver's Side. I can't find that color. Is it under the hood or inside the car???

Thanks

Replies:

Posted By: KarTuneMan
Date Posted: February 19, 2005 at 11:58 AM

Black and orange @ the ECM behind the glove box , OR under the hood. On the four banger, its on the end of the drivers side valve cover in a whitish grayish plug with 4 wires stickin out of it. Use the black one.

On the 6 cylinder, go to the coil on the DRIVERS side,and use the yellow/red

-------------

Posted By: illmattix
Date Posted: February 19, 2005 at 1:44 PM

Thanks Guys.

Posted By: illmattix
Date Posted: February 19, 2005 at 4:15 PM

Alright, I can't seem to find anything yellow/red at the left shock tower or anywhere on the driver's side under the hood for that matter. I'm also having another problem. I'm getting the starter relay to engage when i try to remote start but the car won't start. Is there some kind of security thing that i need to buy a bypass for???

Posted By: thepencil
Date Posted: February 20, 2005 at 7:44 AM

Tach signal has to be learned first!

-------------
Be careful whose advice you buy, but be patient with those who supply it. posted_image

Posted By: johnnyb1231
Date Posted: February 20, 2005 at 9:25 AM

on just about every car i do i use the "uncommon colored" wire off of one of the coils or fuel injectors... on most toyotas however i usually just drop the glove box and pull it off the ecm

dont know if this will be any help but just some food for thought

Posted By: 10nesne1
Date Posted: February 20, 2005 at 10:11 AM

Here is the info. Good luck

TACH BLACK OR GRAY (-) SEE NOTES*

* 4 CYLINDER MOTOR USE THE BLACK WIRE IN THE GRAY PLUG AT THE COIL ON THE DRIVERS SIDE OF THE MOTOR 6 CYLINDER MOTOR USE THE GRAY WIRE LOCATED AT THE IGNITOR ON A BRACKET JUST IN FRONT OF THE STRUT TOWER. THE MODULE SAYS DENSO ON IT