Print Page | Close Window

2000 Altima

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=50481
Printed Date: October 31, 2024 at 6:40 PM


Topic: 2000 Altima

Posted By: meh66
Subject: 2000 Altima
Date Posted: February 20, 2005 at 8:40 AM

I put an Autopage Keyless and remote starter on a 2000 Altima yesterday. All went well except when I was looking for the factory horn wire. In an effort to locate the horn wire, I disconnected a harness that went into the steering column. I did this because my source for the horn wire was incorrect and I did not want to trigger the air bag. I eventually found the horn wire. I thought by disconnecting the harnesss, I would avoid any possibility of causing an airbag issue. However, the airbag light is flashing now. I wanted to know did I cause this by unplugging the harness and if it would eventually stop flashing. I did test two wires, but they wason the plug side away from the steering column. Any help is much appreciated.

-------------
MEH66
"Car Performance and Mobile Electronic Enthusiats"



Replies:

Posted By: wblakes
Date Posted: February 20, 2005 at 9:35 AM
i did an install on my brothers last year and i unplug a lot of harness at the steering column and nothing happened.




Posted By: chris354
Date Posted: February 20, 2005 at 9:35 AM

Probally so you should never unplug airbag wires with battery connected.





Posted By: meh66
Date Posted: February 21, 2005 at 8:11 AM
I appreciate the input, but will I have to get the airbag code cleared or will it eventually go away after several starts?

-------------
MEH66
"Car Performance and Mobile Electronic Enthusiats"




Posted By: radkonn
Date Posted: February 21, 2005 at 10:20 AM
I wrote these procedures down after I found them on another site. I can't find the post now, but it may be worth a try. It is suppose to get you into the diagnostic codes for the SRS for Nissans.


(2001 and older)
1. Open front door LH.
2. Turn ignition switch ON.
3. Press front door switch LH at least 5 times within 7 seconds
after turning ignition switch ON.
SRS is now in Diagnosis mode.
4. “AIR BAG” warning lamp operates in Diagnosis mode

Note the pattern of the blinking (X long blinks followed by Y short blinks) and the number of short blinks will indicate what it is complaining about:
1 is the driver's seatbelt pre-tensioner
2 is the driver airbag
3 is the passenger seatbelt pre-tensioner
6 is the crash zone sensor on the radiator support
7 is the airbag diagnosis sensor
8 is the passenger airbag
9 is the passenger airbag deactivation switch

I believe if there is no fault detected, or it is not seen again after you exit the diagnostic mode it will clear. Let me know if it works. Also, I have the procedure for 2001 and up Nissans as well.






Print Page | Close Window