Print Page | Close Window

Door Ajar Alert Problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=52789
Printed Date: October 31, 2024 at 6:45 PM


Topic: Door Ajar Alert Problem

Posted By: vtec
Subject: Door Ajar Alert Problem
Date Posted: March 29, 2005 at 8:22 AM

My alarm has a feature that will alert me when I've left any of my doors open and I try to arm it. The wire I've connected my alarm to is my dome light wire and this light goes out immediatly when I close my door.

Now the problem:

Everytime I open then close my door and try to arm the alarm within around 2 - 5 seconds it will alert me asif my door is opened. If I do the same as above but wait for more than 5 seconds it will work fine.

Did I use the wrong wire or the wrong part of the wire?



Replies:

Posted By: jaurora
Date Posted: March 29, 2005 at 1:41 PM
This is caused by a slight domelight delay. As you shut the door the voltage being supplied to the dome light starts to disapate after a few seconds or however the factory has it set.. This is normal on some vehicles.

-------------
MECP certified (If it really means anything)
Jeremy




Posted By: vtec
Date Posted: March 29, 2005 at 6:31 PM
Is there anything I can do about it?




Posted By: ccroadshop99031
Date Posted: March 29, 2005 at 7:57 PM
you can catch and diode isolate all door triggers




Posted By: radkonn
Date Posted: March 29, 2005 at 9:00 PM
Check your alarm programming; it might have a door ajar delay feature. I had to activate it in my alarm.




Posted By: vtec
Date Posted: March 29, 2005 at 11:38 PM
Nah my alarm doesn't have that feature radkon.

What do u mean "you can catch and diode isolate all door triggers" ccroadshop99031? (This is my first install, everything works bar this problem)

Thanks for helping me out guys.




Posted By: radkonn
Date Posted: March 30, 2005 at 11:01 AM

He means to find all the door triggers and diode isolate them instead of using the dome light.




Posted By: ccroadshop99031
Date Posted: March 30, 2005 at 12:09 PM
the actual wire running out of all 4 door  and but a diode inline  search for diode isolation





Print Page | Close Window