Viper 791xv LED install question

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54141
Printed Date: April 28, 2024 at 11:26 PM

Topic: Viper 791xv LED install question

Posted By: Smoke Signals
Subject: Viper 791xv LED install question
Date Posted: April 18, 2005 at 8:48 AM

I am relocating the LED to the overhead console but when I extend the wire (approximately 8' of additional wire) the LED no longer works. I've double checked my connections to make sure I didn't get the polarity reversed and everything looks okay.

I'm wondering if that additional wiring would cause enough drop to keep the 2 volt output from powering the LED?

Any suggestions would be appreciated.

Replies:

Posted By: Powermyster
Date Posted: April 18, 2005 at 8:58 AM

8' is a good distance i would have thought it would be ok

could try better cable??

Print Page | Close Window