Transponder and Viper 550esp
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=5554
Printed Date: May 31, 2024 at 3:23 AM
Topic: Transponder and Viper 550esp
Posted By: jimmygunz3
Subject: Transponder and Viper 550esp
Date Posted: November 17, 2002 at 2:49 PM
I installed a viper 550esp and I also needed a transponder bypass. The only problem that I am having is that I need a neg output from the alarm when remote start is activated. I was told to use the WHITE/ blue wire from the alarm which is a remote start activation input. But I need an neg output. When I remote start it, the transponder is not acitvated. If I physically ground the transponder wire and then remote start it works fine. Does anyone know what wire I have to use to get a neg(-) output from the alarm when remote start is activated? Thanks alot...
Replies:
Posted By: camry0099
Date Posted: November 17, 2002 at 6:06 PM
Hi, The blue/black wire on the 6pin H-3(Remote start harness) that is called the optional third ignition wire will work fine. It is a (-) neg output 200ma. The WHITE/ blue wire is a input to start vehicle. ------------- camry9298
Posted By: chriswallace187
Date Posted: November 17, 2002 at 6:55 PM
Also, if you're using the third ignition wire, the blue status output in the 6-pin harness will work.
-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
Posted By: djfearny2
Date Posted: November 17, 2002 at 7:10 PM
the blue status output is the one you need cause it sends a ground pulsed info signal to the transponder do this and your good to go this is the right way to do it.
-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.
Posted By: joelr7309
Date Posted: November 18, 2002 at 3:07 AM
I have a 550esp and I used the H3/1 blue wire, use a relay if its a manual transmission, I used it on an Integra 5 speed,
-------------
THE ROOKIE!~
Posted By: jimmygunz3
Date Posted: November 18, 2002 at 2:38 PM
I used the blue wire, It works good. Thanks alot for the help..
|