Hey can you guys I am back, can you guys give the wire diagram for a 2001 dodge Ram for remote start. prestige plat. aps 785
-------------
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|red and pink/black |+ |ignition harness |
| STARTER|yellow |+ |ignition harness |
| IGNITION|dk. blue |+ |ignition harness |
| SECOND IGNITION|BLACK/ orange |+ |ignition harness |
| ACCESSORY|BLACK/ white |+ |ignition harness |
| POWER LOCK|ORANGE / purple *1 |5wi|driver door harness |
| POWER UNLOCK|pink/purple *1 |5wi|driver door harness |
| LOCK MOTOR|ORANGE / black | |driver door harness |
| UNLOCK MOTOR|pink/black | |driver door harness |
| DISARM DEFEAT|no progressive unlck| | |
| PARKING LIGHTS +|BLACK / YELLOW | |headlight switch |
| HEADLIGHTS|lt. green *5 |- |headlight switch |
| DOOR TRIGGER|yellow *2 |- |headlight switch or DKP |
| DOME SUPERVISION|use door trigger | | |
| FCTRY ALARM ARM|lt. GREEN/ orange |*3 |driver door harness |
|FCTRY ALRM DISARM|same wire | | |
| TACHOMETER|BLACK/ gray *4 | |ignition coil |
| SPEED SENSE|WHITE/ orange | |C2, pin 27 @ PCM |
| BRAKE WIRE|WHITE/ tan |+ |brake pedal switch |
| HORN TRIGGER|BLACK/ red |- |steering column |
| WIPERS|RED / blk & RED / yel |+ |steering column |
| LF WINDOW UP/DN|lt. blue - white |A |drivers window switch |
| RF WINDOW UP/DN|brn/wht - pur/wht |A |driver door harness |
| RADIO 12V|pink |+ |radio |
| RADIO GROUND|BLACK/ blue |- |radio |
| RADIO SWITCH|RED / white |+ |radio |
| RADIO ILLUMINATE|orange (dimmer) |+ |radio |
| POWER ANTENNA|lt green(amp remote)|+ |radio |
| LF SPEAKER|green - brn/red | |radio |
| RF SPEAKER|purple - blu/red | |radio |
| LR SPEAKER|brn/yel - brn/lt blu| |radio |
| RR SPEAKER|blu/wht - blu/org | |radio |
Notes:
*1 Keyless models use positive trigger for lock, and 5-wire for unlock. Can also find wires at the central timer module to the right side of the steering column, lock is ORANGE / green, unlock is pink/green. *2 To avoid dome delay, use tan for the drivers door and BLACK/ lt. blue for the passenger door. Both wires are located at the central timer module to the right side of the steering column. Use both wires and diode isolate each. *3 Arm is negative trigger thru a 644 ohm resistor. Disarm is negative trigger through a 1.5K (1500) ohm resistor. MUST use relays. *4 Diesel tach wire is gray/black and diesel wait to start wire is ORANGE / black (-) Both wires are located on the center of the firewall. There are two black plugs, the wires are in the top plug without the white insert. The tach wire can also be found at the ECM on the passenger side firewall in connector C-1, pin 8. If using the org/blk for wait to start causes a shifting or cruise control problem then use a pulse timer relay instead *5 This wire requires a high current negative, must use relay.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Jeff, Do you have some sort of e-book that gives all that info?
-------------
Shawn
I have dealer installed programs and other sources that give me this information. Also, experience with installation, internet sources & just being a pack rat of information makes installations alot easier.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Jeff thanks alot i appriciate it. I had a lot of installs before but got out of the buis. now i guess i am back just havta catch up on my cars again
Owner of the newly reopened AIM Auto Alarms, ha still got a valid DBA and all. go figure.
-------------
Congrats on the new opening ( or should I say reopening ). Doesn't matter what you know... rather what you don't know
. Welcome aboard and if you have any other questions or need help, you know where to come.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA