97 Navigator PATS actual bypass
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=59799
Printed Date: April 28, 2024 at 2:55 AM
Topic: 97 Navigator PATS actual bypass
Posted By: kidtransam
Subject: 97 Navigator PATS actual bypass
Date Posted: July 20, 2005 at 11:05 PM
got a 97 navigator with PATS (ring around the key cylinder)...ok..brought to me because it wont start...had an alarm on it..for some reason it was pulled..the ring setup is messed up(the ribbon is seperated from the ring casing) ive pulled the ring/connector assy. out and im wondering if there is a way to just completely bypass it altogether..(in other words basically remove it...if its not possible..how to I get around this..i would rather just bypass it altogher...the only part of it i left in the vehicle right now..is the wire harness that goes to the box..and the plug for it..the ring and box is off...im wondering if i cant just connect some of those wires together and bypass it..anyway..any help is appreciated......thanx
-------------
With a torch and a big enough hammer...it WILL friggin fit!!
Replies:
Posted By: auex
Date Posted: July 20, 2005 at 11:09 PM
Nope, off to the dealer it goes. If you are clear off this and it was only brought to you to look at, charge an hour labor and tell them to go to the dealer.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: kidtransam
Date Posted: July 20, 2005 at 11:11 PM
cool...ya its not my problem...wats this gonna cost him approx?
-------------
With a torch and a big enough hammer...it WILL friggin fit!!
Posted By: auex
Date Posted: July 20, 2005 at 11:15 PM
Depends on what was screwed up, of courset the harness. But what happens if the harness shorted out something else?
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: kidtransam
Date Posted: July 20, 2005 at 11:18 PM
well the harness itself isnt damaged...just the 4pin ribbon that goes from the ring to the box (bout 2 inches long) was pulled out of the ring..and frankly i dont know how it connects back to it....but the harness going to the box..is fine.
-------------
With a torch and a big enough hammer...it WILL friggin fit!!
|