Valet 562T remote starter and more

I have the Valet 562T remote starter. The wires from the unit are not hooked up for the door locks. I know where the wire come out of the unit. But I don't know where to hook them for the door locks. I have another question after this one. But we will do one at a time.

I have a 2002 Chevy Impala. Also I believe this has a Neg. switch.

Could someone please help me out with this?

Okay thanks

Now could someone walk me thou the hook up? From what I understand you can't just hook them up...

Please....

I need to know how to hook the 2 wires from the unit to the door locks.

Please....

kgerry wrote:

---

do you have the 451M doorlock module?       if you dont, you need it... when you get it, the appropriate instructions are inside the package.....

---

How do I know? I have the valet 562T and this is in an 2002 impala. How do I find out if I have the module?

sneakycyber wrote:

---

You will need to wire up two relays. connect pins 87 to ground connect pin 86 to 12v connect pin 85 to the negative lock and unlock wires from the remote start. From pin 30 on the lock relay connect a 470ohm resistor then connect it to the orange and black wire.. From pin 30 on the unlock relay connect it directly to the orange and black wire.

---

Wow!!! Sounds like alot of work to me!!!! I guess I'll just pay to have it do. I really don't want to do all that (I am able) I don't have enough time in one day.

Thanks for all you help people.. I really like this forum.. I'll be back

Dave 

Dave, use this diagram with 2 relays ( SPDT 30/40 amp relays )

https://www.velocitymotorsport.com/images/install_notes/144.jpg

sneakycyber wrote:

---

How do you guys make all those nice install diagrams?

---

I use Corel Draw 10 to make up my own diagrams. Super easy , but does take time to do.

Velocity Motors wrote:

---

Dave, use this diagram with 2 relays ( SPDT 30/40 amp relays )

https://www.velocitymotorsport.com/images/install_notes/144.jpg

---

Thanks for the diagram.. But where do I use the relays at? Do I use them at the ends of the lock / unlock wires? 

Also where would I find them? Would they have them at radio shack or something?

POWER LOCK      ORANGE / black           gray 24-pin plug @ bcm                Lock and unlock use the same wire. Lock requires a negative trigger with a 470 ohm resistor in-line. Unlock is negative trigger. Must use relays. See
POWER UNLOCK      same wire as lock      -      gray 24-pin plug @ bcm

The above information that was posted before is where you can locate the lock/unlock wire and the output from the  RS/alarm system is required  for pins 85 on each relay. I suggest that if you can not properly read the relay diagram to give this to a professional installer incase you damage something worth more than the cost to get it installed professionally.

Velocity Motors

Sorry, I didn't that a close enough look at it the first time. I thought the black boxes that you had on there were the door lock units.... My Bad.... I understand it now that I have taken closer look at it. I will print it off and give it a try.

But are these relays something that I can get from Radio Shack?

duley3 wrote:

---

But are these relays something that I can get from Radio Shack?

---

Yes you can get these at any RS, Circuit City, Best Buy or Canadian Tire

IS THIS THE ONE?

\I just wanted to make sure this is the right one that I need. The letters are different then the ones you listed. But it's the only 30amp one that I seen there.

Thanks again for your time

Dave

Velocity Motors

Are these the right style of relay?

I meant these......