2006 Mitsubishi Eclipse GT Wiring

I am getting a Visionguard 6000 remote start and alarm system that actually takes pictures of the intruder and then transmits it to the pager. My problem is my car is so new I don't have any wiring info on it. Does anyone know where I can get some info on the wiring like the colors or the wire, location, etc. I hope to install thid next week!

-------------
Rich

12volts	blue / YELLOW (40A)	+	ignition harness
Starter	BLACK / YELLOW	+	ignition harness
Second Starter	N/A
Ignition	red	+	ignition harness
Second Ignition	N/A
Third Ignition	N/A
Accessory	blue/red	+	ignition harness
Second Accessory	blue/black	+	ignition harness
Keysense	blue/red		ign harn or ETACS ECU, pin 30
Notes: This wire rests at ground, and goes to an open circuit when the key is inserted into the ignition cylinder. The ETACS (Electronic Time and Alarm Control System) ECU is attached to the back of the fuse box. The plugs are on the right side edge.
Power Lock	purple to PURPLE / white	-	driver kick or ETACS ECU, pin 33
Notes: The ETACS (Electronic Time and Alarm Control System) ECU is attached to the back of the fuse box. The plugs are on the right side edge.
Power Unlock	lt. GREEN/ red	-	driver kick or ETACS ECU, pin 34
Notes: The ETACS (Electronic Time and Alarm Control System) ECU is attached to the back of the fuse box. The plugs are on the right side edge.
Lock Motor	blue/red	5wi	28 pin plug above fuses, pin 19
Unlock Motor	blue/black	5wi	driver kick or ETACS ECU, pin 22
Notes: The ETACS (Electronic Time and Alarm Control System) ECU is attached to the back of the fuse box. The plugs are on the right side edge.
Parking Lights+	GREEN / WHITE	+	15 pin plug below fuses, pin 2
Parking Lights-	N/A
Hazards	GREEN/ YELLOW	-	switch or ETACS ECU, pin 55
Notes: The ETACS (Electronic Time and Alarm Control System) ECU is attached to the back of the fuse box. The plugs are on the right side edge.
Turn Signal(L)	GREEN/ red	+	15 pin plug below fuses, pin 8
Turn Signal(R)	GREEN/ YELLOW	+	15 pin plug below fuses, pin 13
Reverse Light	RED / blue	+	driver kick, harness to rear
Door Trigger	lt. green (D), yellow (P)	-	see notes
Notes: The driver door trigger is lt. green in a 15 pin plug below the fuses, pin 6. The passenger door is yellow at the ETACS ECU, pin 65. Use both wires and diode isolate each. The ETACS (Electronic Time and Alarm Control System) ECU is attached to the back of the fuse box. The plugs are on the right side edge.
Dome Supervision	GREEN/ orange	-	3 pin plug below fuses, pin 1
Trunk/Hatch Pin	RED / yellow	-	driver kick or ETACS ECU, pin 62
Notes: The ETACS (Electronic Time and Alarm Control System) ECU is attached to the back of the fuse box. The plugs are on the right side edge.
Hood Pin	N/A
Trunk/Hatch Release	white	5wi	driver kick or ETACS ECU, pin 32
Notes: The ETACS (Electronic Time and Alarm Control System) ECU is attached to the back of the fuse box. The plugs are on the right side edge.
Power Sliding Door	N/A
Factory Alarm Arm	lt. GREEN/ black	-	driver kick or ETACS ECU, pin 42
Notes: Meter this wire while turning the key in the driver door key cylinder. This wire will also lock the doors. The ETACS (Electronic Time and Alarm Control System) ECU is attached to the back of the fuse box. The plugs are on the right side edge.
Factory Alarm Disarm	RED / green	-	driver kick or ETACS ECU, pin 25
Notes: Meter this wire while turning the key in the driver door key cylinder. This wire will also unlock the doors with a double pulse. The ETACS (Electronic Time and Alarm Control System) ECU is attached to the back of the fuse box. The plugs are on the right side edge.
Disarm No Unlock
Tachometer	NOT red	ac	any fuel injector
Notes: On the 2.4L, can also go to any ignition coil and use the wire that is NOT BLACK/ orange or black. On the 3.8L, can also go to any ignition coil and use the wire that is NOT BLACK / YELLOW, BLACK/ red or black.
Wait to start	N/A
Brake Wire	green	+	brake pedal switch
Parking Brake	YELLOW /GREEN	-	parking brake switch
Horn Trigger	lt. green	-	switch or ETACS ECU, pin 44
Notes: The ETACS (Electronic Time and Alarm Control System) ECU is attached to the back of the fuse box. The plugs are on the right side edge.
Memory Seat 1	N/A
Memory Seat 2	N/A
Memory Seat 3	N/A

Interface Module:	Category: Immobilizer Bypass	Required: Yes	Type: Transponder
Part #: 556UW
Alternate Part1 #: 555U
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
Notes: Standard on all models.

-------------
Cause I'm So white and nerdy...
First Class Certi-fried installer