clutch switch bypass 96 s-10
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=68718
Printed Date: May 19, 2024 at 4:37 AM
Topic: clutch switch bypass 96 s-10
Posted By: ccroadshopinokc
Subject: clutch switch bypass 96 s-10
Date Posted: December 19, 2005 at 11:30 AM
i got 4 wires, 1 is not active until the clutch is pressed, then it grounds until cranking in which it goes hot
one is ground at all times
one is hot at all times and the las one is ground until cranking, then it goes hot.
please help
Replies:
Posted By: tragik
Date Posted: December 19, 2005 at 2:22 PM
Most likely the one that does nothing until the clutch is pressed and then goes hot during crank it the one you are looking for. to test it, turn the ignition on, an dthen take a FUSED lead and apply 12 volts + to the wire in question. If the car starts, then thats the wire you need. Just take the starter wire from the remote start drectly to it instead of at the ignition switch. Make sure the car is in neutral when you do this or you might die. Thats a heavy price to pay for convienience.
-------------
Northstart.....or start it your damn self.
Posted By: KarTuneMan
Date Posted: December 19, 2005 at 3:20 PM
TRAGIK....nicely put Make sure the car is in neutral when you do this or you might die. Thats a heavy price to pay for convienience. -------------
Posted By: mistahiggs
Date Posted: December 19, 2005 at 10:31 PM
is it legal for CC to install a RS on a standard in OK?
Posted By: mobile1
Date Posted: December 20, 2005 at 4:02 PM
if you have a PURPLE / white wire at the clutch switch, this is your starter wire. done
|