DEI Responder Programming Icons to Zones
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=69528
Printed Date: May 23, 2024 at 12:51 AM
Topic: DEI Responder Programming Icons to Zones
Posted By: mfarver
Subject: DEI Responder Programming Icons to Zones
Date Posted: December 29, 2005 at 8:31 PM
Two questions that I cannot find answer for in any of the DEI docs for the Matrix 10.5:
For some reason the DEI tilt sensor I purchased does not have the 4 pin connector for the Matrix's "optional" sensor port, nor can I find one that does. Does anyone know where A. I can purchase a tilt sensor with the connector, or B. find the connector to a harness (presumably with standard wire colors) or C (vest) what the pinouts of the connector are. I assume the for wires are power, ground, GWA, and trigger, just do not know which is which.
The related question: The Responder remote has icons for Tilt, Glass, Ultrasonic etc. I assume there is some programming step on the remote where I can program the correct icon with the associated zone. Anyone know how to do this?
Thanks
Mark Farver
Replies:
Posted By: hagmanti
Date Posted: December 29, 2005 at 10:13 PM
Red = 12V, black=ground, green or blue is a negative signal when the unit is triggered, and both can go into any negative input. I'm not sure where you'd get the connector for the port; if you go by a shop that sells DEI, they might have some extras floating around for a reasonable price...
Me
|