Valet 561r, 04 Dodge ram

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=71515
Printed Date: May 23, 2024 at 2:16 PM

Topic: Valet 561r, 04 Dodge ram

Posted By: beakerss
Subject: Valet 561r, 04 Dodge ram
Date Posted: January 25, 2006 at 9:18 PM

I am somewhat to a noobie when it comes to installing these paticular RS/KE systems. If someone could please help me figure this out it would be greatly appreciated. I got the concept of where all the wires are going except
-blue (status output) wire in the satellite harness
-WHITE/ red (+) activation input primary harness H1
-WHITE/ blue (-) activation input primary harness H1
and are the wires in the satellite harness really needed?

I am at a loss for these. Can someone please help me!!

Replies:

Posted By: tjdurham
Date Posted: January 25, 2006 at 10:03 PM

Blue status output is to control a bypass or to power an extra ignition it is a low current - output that goes to ground when the rs is activated and shuts off when rs stops

wh\red

wh\blue dont need either

your truck has several accessory wires that nrrd to be powered for RS all execpt your 10 ga blue

get a tech sheet

-------------
tj

Posted By: beakerss
Date Posted: January 25, 2006 at 10:34 PM

Thank you for the reply it helped out quite a bit, but how would i go about getting a tech sheet? i have wiring diagrams of my truck if that is the same thing. i know i am sounding like a moron but i am tired concerning reading on this stuff. Thank you again for any assistance!! posted_image

Posted By: tjdurham
Date Posted: January 25, 2006 at 11:55 PM

same thing

-------------
tj

Print Page | Close Window