Print Page | Close Window

564T wont Program

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=72347
Printed Date: May 11, 2024 at 9:48 AM


Topic: 564T wont Program

Posted By: chiarlanza
Subject: 564T wont Program
Date Posted: February 07, 2006 at 6:35 AM

I recently installed a 654T into a 2005 Acura MDX. Before it left, i programmed a few options w/ the program button.

A few days later, i had to change a setting, but the alarm will not go in to program mode. When you press the program button, Nothing, and eventually, the 2-way transmitter beeps @ you.  I can program the unit w/ the bitwriter however.

Secondly, I enabled passive arming, and the unit arms while driving, regardless of the settings.   I have a feeling the vehicle is not sensing it is running, or on, and trying to re-arm itself. 

Could there be anything else i am missing,  which wire tells the alarm the vehicle is running?

any help would be appreciated.




Replies:

Posted By: gus1
Date Posted: February 07, 2006 at 11:42 AM
The ignition wire....
You may also have turned armed while driving on. But, if it won't go into programming, check your ignition to the brain, followed by the doorpin.

Gus


-------------
Wherever I go, that is where I end up......


Print Page | Close Window