2001 Tahoe remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=72829
Printed Date: May 29, 2024 at 4:57 AM
Topic: 2001 Tahoe remote start
Posted By: abad355ta
Subject: 2001 Tahoe remote start
Date Posted: February 14, 2006 at 6:13 PM
On my remote start, DEI Valet 554R, Everything works fine except the illuminated entry. I used a relay to power the door trigger for the doem lights to come on. I used the neg polarity on the relay, do I need to use a pos polarity? I used the green wire on the alarm as the dome light wire, after the diodes.
help
regards
ToDDR
Replies:
Posted By: redpeppers
Date Posted: February 15, 2006 at 1:32 AM
negitive trigger should be the one that u want to use. Ensure that u taged the green door trigger wire between the BCM and the diode and not between the diode and the alarm.
------------- Where theres is a wire there's a way.
Posted By: Chris Luongo
Date Posted: February 15, 2006 at 7:19 AM
At the BCM, there is a blue/white wire that is a negative-trigger......it becomes a negative whenever you move the dashboard wheel to the "domelight-on" position.
This wire is low-current, with no relay required; connect the DEI's domelight-supervision output directly there.
Yes, you can also activate the domelight by pulsing the door trigger.......but you will sometimes get the "door-ajar" message on the instrument cluster, even if the door is closed.
Posted By: abad355ta
Date Posted: February 16, 2006 at 5:21 PM
Thanks soo much luongo, worked like a charm.
all finished with the install!
ToDDR
|