Print Page | Close Window

Install Manual RT1WAM4R Arctic Start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=73514
Printed Date: May 09, 2024 at 4:44 AM


Topic: Install Manual RT1WAM4R Arctic Start

Posted By: tech-hacker
Subject: Install Manual RT1WAM4R Arctic Start
Date Posted: February 26, 2006 at 2:08 AM

Install Manual RT1WAM4R Arctic Start

Just recently purchased and had installed at the reseller's shop this unit into my car.  I personally felt they were pushing the envelope for additional charges for the extra options like doorlocks, so I declined this at the install time.  The thinking at the time was that when I picked up my car, I would recieve the install manual along with all the other manuals...user and such...

They refused to give me the manual, citing warranty issues and all that.  And continued to deny me the manual even after I explained I fully intended on violating the warranty regardless if they provided it or not, pointing out that having the manual would only assist me in ensuring what I was looking at was the correct harness to the door and trunk controls. 

I'm an electronics engineer, so it is only a matter of reverse engineering the thing and going from there...but I would still like to have a solid confirmation on the wiring just to expedite the doorlock installation.   I have never, ever, in my entire life, been afraid of violating a warranty, or for that matter, have damaged anything I hacked.  Short of sourcing custom ICs, I'm fully capable of repairing the electronics in most consumer products.

I've searched around for whatever I could find on this model, but the pickings are slim.  No problem on user manual searches, but nothing on the install manual with the exception of a near cousin to my unit, a 2W-AS model, which I am presuming is similar, but not fully I/O compatible where the wiring diagram is concerned.  I am going to proceed on the reverse engineering with that document as a guide...but I have my doubts the wire harness colour codes are the same across the model lines.

If someone could provide me with the actual install manual, that would be greatly appreciated.  Or at the very least, the coding table for the harnesses and additional information regarding the programming if required.

Thanks



-------------
if it moves, hack it.



Replies:

Posted By: Velocity Motors
Date Posted: February 26, 2006 at 10:20 AM

Here you go:

https://staub.ca/tech/Manuals/Firstech/cm4200_install_guide.pdf



-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA


Print Page | Close Window