Print Page | Close Window

03 mazda protege 5 remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=74540
Printed Date: May 19, 2024 at 5:55 AM


Topic: 03 mazda protege 5 remote start

Posted By: jeryl
Subject: 03 mazda protege 5 remote start
Date Posted: March 15, 2006 at 7:22 PM

ok i know someone already asked this but i dont have time to look for the post...

1.  my question is the alarm has a wire for oil for remote start ... would that be the same as the tach wire or is it something else...

2. also how would i hook up the door locks because the alarm has 5 wires: also the door locks are only on 1 wire type door lock

no1

nc1

c1

no2

nc2

c2

3. the relays for the remote start, can i tap in the wires from the starter kill to the remote start relays because they use the same-  acc, on, start wires... i already know i need to cut the starter wire in half...

thanks in advance guys!!!




Replies:

Posted By: profuse007
Date Posted: March 15, 2006 at 9:57 PM
the oil is similar to tach but diff being it reading oil pressure. try using volt sense to manually crank the engine.


c1-ground
no1-to lock/unlock, use resistor inline if needed

c2-ground
no2- to lock/unlock, use resistor inline if needed

not too clear on ur 3rd question there.



-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).




Posted By: jeryl
Date Posted: March 16, 2006 at 12:48 AM
thanks... so can i hook up to the low oil pressure ligth switch near the dash or do i have to tap into the oil pressure sending unit wire from the oil sending unit itself... also is volt sense jus another option on the alarm that i can configure??? actually its for my friends alarm and he has the manual i jus wanted to know if u could clarify it for me cause i will look at his manual tomorrow anyways... thanks!!!





Print Page | Close Window