door opening on clifford alarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=74586
Printed Date: May 31, 2024 at 6:55 PM
Topic: door opening on clifford alarm
Posted By: ben k
Subject: door opening on clifford alarm
Date Posted: March 16, 2006 at 2:53 PM
hi chaps i have dehandled my car and put solonoids in the doors the big electro magnet type. and have been trying to wire up a rely to the acc out put to realease the door and cannot do it all i manage to do is get the relay to click. have just been reading up on relays. will this work terminal 86 = 12 v+ 85 = acc output on alarm 30 = to the solonoid 87 = 12v + will this work thanks ben :)
Replies:
Posted By: Twelvoltz
Date Posted: March 16, 2006 at 3:15 PM
Are you saying that this is how you have it wired or are you trying to verify that this is correct? If the solenoid that you are wiring requires just a positive and negative to activate, then yes you have it correct. When the relay is active terminals 30 and 87 are connected, when the relay is not active terminals 30 and 87a are connected.
Posted By: ben k
Date Posted: March 16, 2006 at 3:19 PM
hi havent wired it like this yet have been racking my brains and this is what i came up with haven really used relays much before thanks for that :)
Posted By: joe_1
Date Posted: March 16, 2006 at 3:19 PM
try switching the 2 leads on the solonoid, the one you have on the relay going to the solonoid and the one you have earthed to the vehicle, switch these over as you may have these connected wrong.
-------------
i am also a technician so if you have any engine trouble let me know, and i will do my best to help.
Posted By: ben k
Date Posted: March 16, 2006 at 3:20 PM
will the acc output on the alarm be - cheers ben
Posted By: Twelvoltz
Date Posted: March 16, 2006 at 3:23 PM
I do not recall ever seeing a + second channel output on any system so yes it is a negative output. Make sure you fuse your supply to the relays as close to the source as you can.
Posted By: joe_1
Date Posted: March 16, 2006 at 3:26 PM
yes the clifford will be neg output
-------------
i am also a technician so if you have any engine trouble let me know, and i will do my best to help.
Posted By: ben k
Date Posted: March 16, 2006 at 3:28 PM
cheers for that will try it tommorow thanks ben
Posted By: ben k
Date Posted: March 16, 2006 at 4:16 PM
just tried it and it works cheers ben
Posted By: joe_1
Date Posted: March 17, 2006 at 10:28 AM
what was it then?
-------------
i am also a technician so if you have any engine trouble let me know, and i will do my best to help.
Posted By: ben k
Date Posted: March 17, 2006 at 10:39 AM
had the reley wired the wrong way doh
|