Print Page | Close Window

530t

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=76179
Printed Date: May 03, 2024 at 11:00 PM


Topic: 530t

Posted By: dude222
Subject: 530t
Date Posted: April 13, 2006 at 1:19 PM

Hello

I want to install a 530t in my 2001 chevy silverado it has one touch operation drivers door only.

i already have a 552t remote start in the truck and it controls the factory alarm and locks the doors.

Were would i find the wires for the windows (door panels at the motors)? would i need any relays?

the 530t needs a ground when armed would that be the blue wire from the 552t? will that be the same wire that controls the factory alarm? do i tie those wires together to control both?

Thanks




Replies:

Posted By: Twelvoltz
Date Posted: April 13, 2006 at 1:32 PM
The 552T has a negative when armed output. It is the Orange wire on H1, this would be the wire that goes to the Orange on the 530T. There is a RED / white channel 2 output from the 552T that normally controls a trunk release, you can use that to the RED / white on the 530T to roll down. The window wires you need to interface are in each door.

LF Window up/dn      blue - brown       type A       driver door switch
RF Window up/dn     blue - brown       type A       passenger door switch

Hope this helps.

Keep us posted.



Posted By: integratyper934
Date Posted: April 30, 2006 at 1:23 AM
if you thought the blue wire was a ground when armed ou should take it to a professional.


Print Page | Close Window