95 jeep grand cherokee
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=77829
Printed Date: June 10, 2024 at 11:27 AM
Topic: 95 jeep grand cherokee
Posted By: godsegoizhuge
Subject: 95 jeep grand cherokee
Date Posted: May 15, 2006 at 7:13 PM
Hi, I'm looking to install a dei 530T power window module onto my jeep and i'm wondering if there's a way to get the wires through the plug at the door? I know I might have to drill a hole, but I was hoping I can drill a hole at the plug so I can run the wires along with the other factory one's.
Replies:
Posted By: swamprat323
Date Posted: May 16, 2006 at 3:25 AM
go through the door boot, you may have to unplug the boot at both ends to fit the wire though.
Posted By: godsegoizhuge
Date Posted: May 16, 2006 at 7:14 AM
The side of the boot that goes into the car is fine, it's the side of the boot that goes into the door that there's a problem. It's similiar to how they have it on the honda's with that plug there at the door.
Posted By: Velocity Motors
Date Posted: May 16, 2006 at 8:40 AM
You will need to push the plug from the inside out and when it's out you have to drill a hole into the connector to run your wires through it.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
|