Has anyone hooked up these chevy blazer door locks before?
The info on this site in the wiring diagrams section says the following...
Are both of these reverse polarity?
Ok now, my black widow X-5 has basically five wires to connect if i follow the reverse polarity instructions for both the lock and unlock circuits. Basically the brain of the alarm acts like a relay i believe in this configuration. so i break the original continuity of the lock circuits and then each wire from the module goes into the appropriate wire which was cut, then I put 12 volts to the module and the locks work.....
Is this correct?
Also, i dont think i can hook my dome light input to the door pins circuit which is negative ground style i believe on the chevy blazer, because i looked inside the brain and the circuit that is labeled dome is burnt up,,, happened today when i installed the alarm and i smelt and saw smoke and unplugged it right away... hopefully the alarm is still good, the circuit s just burnt it may still be ok....though the alarm manual itself states that you can hook the dome to either a positive or negative door pin system... confusing... now what do i do with the dome?
Any input would help me alot...
-------------
DKH
make sure u have a good battery also.
-------------
dragon
