03 Eclipse clutch bypass problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=81756
Printed Date: June 08, 2024 at 5:54 AM

Topic: 03 Eclipse clutch bypass problem

Posted By: Raymond4646
Subject: 03 Eclipse clutch bypass problem
Date Posted: August 18, 2006 at 5:22 PM

I have verified that the two wire clutch is a type 4. If you remove the two wire plug the vehicle starts. I first had the clutch bypass working with one of the factory clutch wires interrupted with the outputs from the relay. I also had 12 V from ignition going to 86 and ground going to 85. Now it seems that since I had to diode isolate the starter interrupt for my 530t to work it no longer works. Can anyone give me the correct way to wire this relay so I dont have to compromise the safety of the switch. Thank you very much for looking!!!!

Replies:

Posted By: KarTuneMan
Date Posted: August 18, 2006 at 5:32 PM

What did you install?

Posted By: Raymond4646
Date Posted: August 18, 2006 at 6:47 PM

KarTuneMan wrote:

What did you install?

Sorry about that, a Compustar 2w900fm-as with a 530t and a 545t. Thanks

Posted By: bbtaco
Date Posted: August 18, 2006 at 11:08 PM

Connect one side of the cut wire to 87a. Connect the other side of the wire to 30. Connect 86 to your ignition wire and 85 to the Compustar black Status out wire in connector 2, pin 2. Make sure you have the ebrake wiring hooked up.

Posted By: Raymond4646
Date Posted: August 18, 2006 at 11:27 PM

bbtaco wrote:

Connect one side of the cut wire to 87a. Connect the other side of the wire to 30. Connect 86 to your ignition wire and 85 to the Compustar black Status out wire in connector 2, pin 2. Make sure you have the ebrake wiring hooked up.

Thank you very much!!!!