passlock I, resistor/relay method

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=84799
Printed Date: June 05, 2024 at 12:23 AM

Topic: passlock I, resistor/relay method

Posted By: JIMMY 2 TIMES
Subject: passlock I, resistor/relay method
Date Posted: October 29, 2006 at 8:22 AM

I am looking at tech tip, 1047 (gm passlock I bypass) I see that there are 2 relays, what is the 2nd one for?

and my next question is, where do i connect both pin87 on each relay? (i know the black wire on the 3 wire ribbon) but can they be connected at the same point, or do i need to cut it, and connect one on each side of wiring.

no local stores have the 555lw in stock, and i dont want to really wait

Replies:

Posted By: Big Dog
Date Posted: October 30, 2006 at 3:37 PM

2nd relay is bulb check....it must see a ground before passlock resistor.

Connect 87 and 87a of the first relay as per diagram to the passlock ground reference wire.

Pin 87 bulb check goes on small black wire found in the ignition connector with the two RED main 12v positive wires.

-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.

Print Page | Close Window