Print Page | Close Window

2005 grand cherokee remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=86665
Printed Date: October 31, 2024 at 6:31 PM


Topic: 2005 grand cherokee remote start

Posted By: tireman
Subject: 2005 grand cherokee remote start
Date Posted: December 05, 2006 at 8:33 AM

I just installed a Bulldog RS in an 05 Grand Cherokee. I hooked up the Accessory and 2nd starter like this:https://64.85.6.129/extrainfo/diagrams/26500_GRAND-CHEROKEE_CHRYSLERS%20STARTER%202%20AND%20ACCESSORY%20DIAGRAM.pdf">Relay diagram

Now when I shut the vehicle off It diesels until the fuel stops. There is not a crisp ignition stut down. This happens whether I use the sterter or the key to start it. I tried to disconnect the white wire on the 86 terminal on the acc relay and the problem goes away... except now I have no acc while running.

Any ideas??

Keep in mind I am a Newbie!





-------------



Replies:

Posted By: Hymer
Date Posted: December 05, 2006 at 8:50 AM
you could try a 610 ohm instead of a 560 ohm.. It may need to seek 1k to ground at shutoff.. Call The resistances are probably out of tolerance.. recheck them

-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair




Posted By: tireman
Date Posted: December 09, 2006 at 8:38 AM
Is it possible that I have the diode on the starter 2 relay going the wrong way?




Posted By: KarTuneMan
Date Posted: December 09, 2006 at 12:30 PM
It is poss. remember, a diode can "stop" both 12volts, AND ground....

-------------




Posted By: tireman
Date Posted: January 05, 2007 at 4:53 PM
Just in case others may run into this -... I had to diode isolate the white wire on the acc realy.  Problem solved works perfect.  Thanks for the help.





Print Page | Close Window