Viper 791XV cranks during Valet Take-Over
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=86693
Printed Date: May 02, 2024 at 12:58 AM
Topic: Viper 791XV cranks during Valet Take-Over
Posted By: jnice
Subject: Viper 791XV cranks during Valet Take-Over
Date Posted: December 05, 2006 at 9:46 PM
I just got done installing the alarm in my Cherokee. For some reason (not everytime) when I perform the Valet-TakeOver, it cranks until I shut it down by brake etc.
I press the * button twice, and sometimes it will go back into remote start like it should, other times it just cranks! Anyone have any experience with this?
-------------
Do it right the first time
Replies:
Posted By: mauri197
Date Posted: December 05, 2006 at 10:52 PM
make sure you have the correct tach wire i had that happen to me once my connection on my tach wasnt so ggod it would see sometimes and sometimes it wouldnt especially when i tried to do pit stop sounds like a tach problem to me but double check everything what year cherroke is this
Posted By: jnice
Date Posted: December 06, 2006 at 8:12 PM
It is a 96. Yeah I thought that too at first, but when I did the tach learning it was good, led came on steady like it should. Shouldn't the alarm know that it is running from the ignition wires? I know it senses the tach, but it should know that it is already running and not crank right?
-------------
Do it right the first time
Posted By: cntrylvr79
Date Posted: December 06, 2006 at 8:32 PM
Where'd you pick up the tach signal? Is it a regular cherokee or grand cherokee?
-------------
Cause I'm So white and nerdy...
First Class Certi-fried installer
|