2001 Dodge Dakota, Alarm, Remote Start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87967
Printed Date: June 15, 2024 at 8:43 PM
Topic: 2001 Dodge Dakota, Alarm, Remote Start
Posted By: adamski
Subject: 2001 Dodge Dakota, Alarm, Remote Start
Date Posted: December 28, 2006 at 11:12 PM
1. I’ am in the middle of installation huatai HT-800s to Dakota 2001, do I need to have the DIODE installed in the pin trigger wire??, I tried without but no chance to work, when I try to remote start it I’ am receiving 3 sounds but no starting.
2.after arming the alarm, the siren will sound indefinitely, Disarming the alarm arming again the same case will happen again. Please someone help me.
3.do I have to connect the hand break wire if my vehicle is automatic, will it work without connecting it?
I need help badly.
Thank you.
-------------
Adam
Replies:
Posted By: KarTuneMan
Date Posted: December 29, 2006 at 8:19 AM
Might you have your diodes facing the wrong direction? (for door trigger isolation) The vehicle IS equipped with a transponder ign. What bypass did you use? How is it wired? You don't need the hand brake wire for an auto trans. -------------
Posted By: adamski
Date Posted: December 30, 2006 at 9:36 AM
Yes I used the bypass, I tested the bypass it works properly, but I still have problem with the starter, as soon as I plug the power wire and the rest wires, the unit arming the alarm itself, the siren will sound indefinitely.
Please Help.
-------------
Adam
Posted By: adamski
Date Posted: January 04, 2007 at 9:52 PM
2001 Dodge Dakota I'm installing car remote starter with alarm AS Aftermarketgeneration it's made by Automate
I'm trying to make power locks work I used 820ohm Lock Resistor and 330ohm Unlock, through relays but no luck, do I need to connect all the door trigger for power locks to work?? what may be the problem? pls give me advice.
Do I need to do features programming routine for the locks to work??
-------------
Adam
|