2007 chevy malibu

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90925
Printed Date: May 29, 2024 at 5:54 AM

Topic: 2007 chevy malibu

Posted By: 05gt
Subject: 2007 chevy malibu
Date Posted: February 24, 2007 at 2:36 PM

I am working on this car right now, and I need to know how to wire up the DEI 451m doorlock module to this car, this module came with the clifford rs1.1 remote start system that I am using

thankyou mike

Replies:

Posted By: concepts99
Date Posted: February 24, 2007 at 3:59 PM

LOCK

White

In driver's kickpanel or Pin-66 on C1 @ BCM/Fusebox

This is a single wire door lock system. A ground pulse will lock the doors, ground through a 1500-ohm resistor will unlock the doors. See the door lock diagram for exact wiring instructions. The BCM/Fusebox is located on the passenger side of the center console. C1 is the GRAY connector on the lower left. See the provided diagram for exact location.

UNLOCK

White

In driver's kickpanel or Pin-66 on C1 @ BCM/Fusebox

Posted By: 05gt
Date Posted: February 24, 2007 at 6:15 PM

thanks, but I already have that, I wanted to know how to wire the dei451M to the car

thanks

Posted By: lsondubz
Date Posted: February 24, 2007 at 6:33 PM

Wire as follows;

PURPLE / blk with fuse; Ground

BROWN / blk and WHITE/ blk not used

Blue/blkl; 1500ohm resistor inline then out to lock wire in car(white)

GREEN/ blk; out to lock wire in car(white)

the 3 pin harness should plug into the brain with (lt green neg lock) (blue shoulld be neg unlock) and red should be 12V