powerstroke diesel, crimestopper?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=92997
Printed Date: May 10, 2024 at 6:04 AM
Topic: powerstroke diesel, crimestopper?
Posted By: greendually
Subject: powerstroke diesel, crimestopper?
Date Posted: April 16, 2007 at 5:16 AM
I installed a crimestopper alarm/starter in my truck.When i start the truck with the remote sometimes the truck will not start and the alarm will sound.But if i turn off the alarm the truck will start.It almost seems like the shock sensor is turning back on and stopping the starting process after it has started turning the starter over.
Replies:
Posted By: Hymer
Date Posted: April 16, 2007 at 8:21 AM
disable the shock sensor, and arm it then start it for a few days, that should tell ya if its the shock sensor. If it is, then set the sensitivity down, and or remount it somewhere else..
-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair
Posted By: greendually
Date Posted: April 17, 2007 at 3:00 PM
Well i turned the shock sensor all the way down,still did the same thing.Anyone have any ideas that i could check.
Posted By: KarTuneMan
Date Posted: April 17, 2007 at 3:21 PM
How did you wire the "wait to start" Where did you connect at? What year is your truck? -------------
Posted By: greendually
Date Posted: April 17, 2007 at 4:23 PM
I didnt wire in the wait to start,i used a 20 sec delay.
All the connections are under the steering colum,what colors,i dont remember off hand.
My truck is a 2003 f350 7.3 diesel.
Thanks for your help.
Posted By: KarTuneMan
Date Posted: April 17, 2007 at 5:51 PM
When the alarm is triggered....what zone does the LED tell you was set off? Does it say "shock sensor" (the # of flashes)
-------------
Posted By: greendually
Date Posted: May 08, 2007 at 5:27 PM
KarTuneMan wrote:
When the alarm is triggered....what zone does the LED tell you was set off? Does it say "shock sensor" (the # of flashes)
when the alarm goes off,it says the doors got opened.Could it be the door trigger?
Posted By: KarTuneMan
Date Posted: May 08, 2007 at 6:55 PM
Could be the bcm wake up, or yes, the door pin! How did you catch the door pins? where? Did you isolate the pins?
-------------
Posted By: greendually
Date Posted: May 09, 2007 at 3:51 AM
I used the door dome light trigger.
Posted By: greendually
Date Posted: May 10, 2007 at 3:17 PM
I did install diodes (i think thats what there called) to the trigger wire from the dome light wire.
Posted By: greendually
Date Posted: May 16, 2007 at 6:36 PM
Anyone ??????
Posted By: z96cobra
Date Posted: May 20, 2007 at 11:41 PM
On my 2002 F350 PSD, if it doesn't start, the dome light comes on and this will set off the alarm. What zone is setting the alarm off? Check the # of flashes on the led and let us know.
Roger
|