2002 jeep liberty, autopage

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=96996
Printed Date: May 17, 2024 at 7:19 PM

Topic: 2002 jeep liberty, autopage

Posted By: tek1001
Subject: 2002 jeep liberty, autopage
Date Posted: September 09, 2007 at 1:45 PM

Hi hope someone out there can help me out I have a 2002 jeep liberty I installed a autopage alarm remote start with db-chdl4 well it seem to work fine except the rear hatch will not unlock from the autopage remote when the door locks open but if i use the factory keyless entry remote the hatch will open and unlock and today the it only unlocks the door some times and the autopage remote flashs open door when arming and some time it will not arm or disarm any help would be great thank in advance.

-------------
tek1001

Replies:

Posted By: eurobink
Date Posted: September 09, 2007 at 6:58 PM

read what you just wrote... see if you can make out what it says..

then rewrite it so we can understand exactly whats going on and we will help you

Posted By: tek1001
Date Posted: September 09, 2007 at 11:34 PM

well it worked fine except could not get the rear tailgate door to unlock from remote the relay clicks when i push the button on the remote but will not unlock the tailgate and now the doorlocks work fine from the switch but not the remote.they work some times and there are times when they do not work i have gone over the wiring it seems correct.If I use the factory keyless entry remote to unlock the tailgate that works and then i can used the after market remote to unlock the tailgate but it will only work one time then the tailgate will not unlock from the after market remote until i use the factory remote first.I was wondering if it could be a problem with the databus mod i used the db-chdl4 from omega.

-------------
tek1001

Posted By: shaip99
Date Posted: September 10, 2007 at 6:33 PM

how did you connect your wires did you use t-taps or did you solder if you used t taps rip the whole thing out and do it again with solder and tape if you used solder and tape pull off all your tape and check for cold solder joints on your connections

by your description is sounds like you have a few bad connection that are intermittantly failing

or another option is that i have completely missunderstood what you were writing cause it made little sence

-------------
"Computer games don't affect kids, I mean if Pac Man affected us as kids, we'd
all run around in a darkened room munching pills and listening to repetitive
music."-Kristian Wilson, Nintendo Inc.