Print Page | Close Window

2003 nissan xterra starter grind

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=98121
Printed Date: October 31, 2024 at 6:56 PM


Topic: 2003 nissan xterra starter grind

Posted By: advanced
Subject: 2003 nissan xterra starter grind
Date Posted: October 19, 2007 at 5:57 PM

I installed an Audiovox APS-57 in a 2003 Nissan Xterra & everything works fine, except when I remotely start it & then I get in & put the key in the ignition & turn it to go, I get a starter grind noise as I'm turning the ignition to "on" position.

There's no transponder in key.

I can't figure it out. Any Ideas??  



-------------
Good Enough Isn't!



Replies:

Posted By: Twelvoltz
Date Posted: October 19, 2007 at 6:34 PM
How did you wire up the second starter output?

-------------
Installer, IT support, and FFL. I need less hobbies.




Posted By: advanced
Date Posted: October 19, 2007 at 7:03 PM

First I tied the 2 starter wires together to the remote start "starter" wire. In an effort to find the problem, I then isolated the 2nd starter wire with a relay. The same thing happens.



-------------
Good Enough Isn't!




Posted By: NowYaKnow
Date Posted: October 19, 2007 at 7:12 PM
From another post

#85 to the negative out when running wire from the remote starter; #86 to ignition; #87 to the starter wire from the remote start; Cut the vehicles starter wire - #87a to the key side of cut starter wire; #30 to the starter motor side of the cut starter wire





Print Page | Close Window