2008 dodge nitro remote start/keyless
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=98829
Printed Date: April 27, 2024 at 4:25 PM
Topic: 2008 dodge nitro remote start/keyless
Posted By: last
Subject: 2008 dodge nitro remote start/keyless
Date Posted: November 09, 2007 at 10:53 PM
I worked with this nitro tonight and could not find the lock/unlock wire for the life of me.... no violet/green GREEN/ violet anywhere driver or passenger door harnesses.
violet/orange looks like a data wire that would control them but toasted a fuse when i tried any signal. the normal 330 ohm lock and 1k unlock or the other way around.
Newest information i could find was 2007 guide, directechs didn't have 2008 info either.
anyone know anything that would have helped me?
Replies:
Posted By: mrjc480
Date Posted: November 10, 2007 at 12:02 AM
I just did a 07 last weekend. I grabbed the locks in the passenger door PURPLE / lt green through a 1k and a 180 ohm res. This was a PITA. I had to cut the front door triggers from the BCM and diode isolate them in addition from each other because they were being triggered 60 sec after locking/arming.
------------- Im moving to MEXICO and Im not speaking spanish!
Posted By: extreme1
Date Posted: November 10, 2007 at 12:22 AM
idatalink ads-al-ca will do keyless, alarm, door and trunk outputs as well as ign mux wiring, add an ads-rngc2 and you have your transponder bypass.
------------- Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: last
Date Posted: November 10, 2007 at 11:24 AM
the 08 didn't have the same color wire as the 07, went to both doors, the only wire that looks like it controls the locks is a violet/orange, theres a group of 3 wires, one ground i think white green, another white with a color and the violet orange in a connector on the lock/unlock button but resistance didn't seem to change when i tested it, leads me to believe they are data.
i think i need a door lock module. that idatalinkads-al-ca sounds like it would work.
|