Print Page | Close Window

06 commander accessory wire?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=99808
Printed Date: October 31, 2024 at 8:00 PM


Topic: 06 commander accessory wire?

Posted By: stiver_32
Subject: 06 commander accessory wire?
Date Posted: December 09, 2007 at 12:13 PM

I am about to install a valet remote starter for a friend and I can not find any info on which wire to use for the Accessory (Heater Blower).

Also wondering where is the best place to hook up the parking light output (-).

Any help is greatly appreciated.




Replies:

Posted By: KarTuneMan
Date Posted: December 09, 2007 at 12:30 PM

Use a CAN bypass module..... makes the job a tad bit easier.

The parking lights... abit more tricky. You need to get to the light relay under the hood. Its the relay that is closest to the fender in the fuse box. Solder a negative parking light output to the first pin on the relay. It's the pin that is closest to the little 10 amp fuse below the relay.




Posted By: stiver_32
Date Posted: December 11, 2007 at 9:17 AM

I thought I'd add this info to my post.... it was sent to me via PM:

The accessory wire is a multiplexed wire in that application. You would need to cut the wire and provide the proper resistance to it during accessory and a different resistance during crank. Here is Audiovox's information on that wire:

https://documents.audiovox.com/701131.pdf

Parking lights are available at the parking light relay under the hood.

https://documents.audiovox.com/701124.pdf





Print Page | Close Window