03 silverado security light

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=111770
Printed Date: June 03, 2024 at 6:18 AM

Topic: 03 silverado security light

Posted By: newman2ng
Subject: 03 silverado security light
Date Posted: February 20, 2009 at 9:53 AM

put a remote start in a basic model silverado. security light stays on when started with the key. I used a bypass kit plzap bypass which requires you to cut the red white wire. The truck remote starts and runs fine just has the light on. I took that bypass out and reconnected the wires and the light still comes on with the key. I installed a gmbp bypass and it programmed and when started with the remote start the light goes out but stills stays lit when you start it with the key. how can i get the light to go out?

thanks

Replies:

Posted By: Big Dog
Date Posted: February 20, 2009 at 10:07 AM

Sounds like it's in "Fail Enable" mode. This is caused by a lack of communication by one of the devices - caused by an open circuit. The system lost the valid r-value after it started and the engine was running. The passlock is bypassed and the car can be hot-wired. Not good.

Re-check connections.

-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.

Posted By: newman2ng
Date Posted: February 20, 2009 at 10:15 AM

Triple checked connections. How can I reprogram the r valueso tv light will go out?